Kramer - KE26-60CDP - 6,000 BTU/h - Low Profile Unit Cooler, Electric Defrost, 208-230/1/60, PSC Motor

Item: KRAKE2660CDP

Product no longer available for sale.


Low Profile Unit Coolers (Models KE; KA)


Features an air draw-through design, easy access for serviceability, and are available as air, electric or hot gas defrost models. Electric Defrost models (prefix “KE”) are designed for use in coolers and freezers between 34°F and to -20°F. Complete electric defrost refrigeration systems are available. These Low Profile Unit Coolers can be used in combination with Kramer’s Next-Gen Kompact K-Series Condensing Units to provide a complete refrigeration solution for small to medium walk-ins.

There are a wide array of sizes available with capacities ranging from 3,600 to 28,000 BTU/h at a 10° TD spanning from 780 to 4,980 cfm. One through six fan models are available.

The embossed Aluminum casing is lightweight yet durable. Each fan section is baffled to prevent short cycling of the air. The unit is designed to mount flush to the ceiling and meets all NSF requirements. The top pan is slotted for simple installation. Drain fittings are installed in the bottom of the drain pan for easy field connection and the drain fitting can be quickly replaced without replacing the entire drain pan.

Copper hairpins are staggered and mechanically expanded into corrugated Aluminum fins and tube sheets to achieve maximum heat transfer. Die formed fin collars provide even fin spacing and are available in 6 and 4 fins per inch. Sweat connections are standard on all models.

Heavy duty 12” Aluminum fans are balanced to provide vibration-free operation. Our low throw black plastic fan guards provide an optimal air pattern. The optional epoxy resin high throw fan guard moves air up to 25 feet.

Available in 208/230V and 460V. All components are factory wired to convenient screw-type terminal strips. A large compartment is supplied internal to the unit for all electrical components and is easily accessible by opening the slide out end panel. All models are UL and cUL listed and are available in 60 or 50 Hz.

Electric Defrost:
Electric Defrost models contain internal coil heaters for rapid and efficient defrost. A lower heater is installed close to the drain pan for fast, reliable drainage. A defrost termination fan delay thermostat (DTFD) terminates the defrost cycle when the temperature is satisfied. The fan delay allows the warm coil to cool after a defrost cycle prior to the fans turning on. A heater safety thermostat is installed to prevent heaters from overheating above 75°F.

California residents: see Proposition 65 Warning

Features and Specification

Weight 54.000000
Height 17.000000
Inlet Connection Size 1/2"
Phase Single
Length 15.125000
Suction Line Size (OD) 7/8"
Liquid Line Size (OD) 1/2"
Width 41.000000
Warranty Offered Yes
Voltage 208-230 VAC
Refrigerant Various
UL Recognized No
UL Listed Yes
Energy Star Rated No
Amps 7
Brand Kramer
Drain Connection Size 3/4"
Cubic Measurement 6.100800
Cycle/Hertz 60 Hz