Duro Dyne - 8233 - RS356 - 1 Spring Bearing, 1 Solid Bearing, 1 Washer, Handle and Wing Nut

Item Number: DDY8233  MFR Part Number: 008233


Vendor Discontinued
see more



Is An Inexpensive, Rattle-Free Regulator For Quick Installation On Balance or Splitter Dampers. It Is Formed From Rust-Resistant, Heavy Gauge, Galvanized Steel and Installs In Seconds. The RAPIT™ Will Penetrate and Secure To Round or Rectangular Damper Blades Up To 24 Gauge Steel. It Has A Fully Retractable Bearing Of Zinc Alloy, Threaded To Accept A 5/16-18 Wing Nut and A Handle That Indicates The Damper Position. It's As Easy To Use As 1-2-3.
  1. Slip The Bearing Over The Edge Of The Damper At The Bearing Line.
  2. Lay The Assembly On Any Firm Surface and rap The Prong with A Hammer. One Blow Drives The Prong Through The Damper Blade, Holding It Securely To The Damper.
  3. When Hit with A Hammer, The Prong Will Automatically Form Up Tight By The Anvil, Which Is Built Into The Bottom Of The RAPIT™ Bearing.

California residents: see Proposition 65 Warning

Weight12 Pounds (Lb)
Width7 Inches (In)
Height11 Inches (In)
Country of OriginUSA
Length13 Inches (In)
BrandDuro Dyne
ColorNot Provided Before Item Discontinued
CompositionNot Provided Before Item Discontinued
FinishNot Provided Before Item Discontinued
GaugeNot Provided Before Item Discontinued
SizeNot Provided Before Item Discontinued