Duro Dyne - 8086 - RS156 - 1 Spring Bearing, 1 Washer, Handle and Wing Nut

Item Number: DDY8086  MFR Part Number: 008086


RS156 - 1 Spring Bearing, 1 Washer, Handle and Wing Nut
see more


The RAPIT™ Is An Inexpensive, Rattle-Free Regulator For Quick Installation On Balance or Splitter Dampers. It Is Formed From Rust-Resistant, Heavy Gauge, Galvanized Steel and Installs In Seconds. The RAPIT™ Will Penetrate and Secure To Round or Rectangular Damper Blades Up To 24 Gauge Steel. It Has A Fully Retractable Bearing Of Zinc Alloy, Threaded To Accept A 5/16-18 Wing Nut and A Handle That Indicates The Damper Position. It's As Easy To Use As 1-2-3.
  1. Slip The Bearing Over The Edge Of The Damper At The Bearing Line.
  2. Lay The Assembly On Any Firm Surface and rap The Prong with A Hammer. One Blow Drives The Prong Through The Damper Blade, Holding It Securely To The Damper.
  3. When Hit with A Hammer, The Prong Will Automatically Form Up Tight By The Anvil, Which Is Built Into The Bottom Of The RAPIT™ Bearing.

California residents: see Proposition 65 Warning

Weight10 Pounds (Lb)
Width7 Inches (In)
Height11 Inches (In)
Country of OriginUSA
Length13 Inches (In)
BrandDuro Dyne